Infinite Irons

Infinite Irons Rolled Rear Shader Spring 0.020" Thick x 1.281" Long

Adding to cart...
Out of Stock
Notify me when back in stock

Enter your email address below to be notified when this product comes back in stock.

Adding to cart...
Adding to cart...
Added to your Favorites.
Infinite Irons Rolled Rear Shader Spring (.020 X 1.281 Long) - These Are The Rear Springs That Joey D. Uses On His Machines That Have Been Sized To Fit His Liners And Shaders. The Spring Length Is 1 9/32 Inches Long Overall And 1 23/32 Inch From The A-Bar Screw Hole Center To The Slot Where An 8-32 Screw Will Fit. It Is Also Slotted At The Rear To Allow For A Longer Distance Between Screws. The Spring Width Is 1/2 Inch Wide. Please Measure Carefully To Figure The Fit Of Your Springs. Measure Carefully.